“Mass finishing for ABS 3D prints
on your desktop. The best companion
for your 3D printer. By SKY-TECH.”
Polish your 3D prints… Magically!
Do you want beautiful, finished prints that wow your
audience, but don’t want to spend so much time,
effort, and money to get them? Then you need an
elegant solution that polishes your creations effortlessly.
You need the MagicBox!
The MagicBox uses an acetone vapor bath to smooth the lines normally present on FDM prints. It’s simple, easy-to-use settings give you control over the look and feel of your creations. Polish out rough edges or preserve detail, it’s up to you.
Easier than saying “ABRACADABRA!” or waving around a magic wand, the MagicBox will give you the look and feel you want from your creations. It polishes ABS and PLA prints to a glassy smooth finish in almost no time at all!
|Product Name||SKYMAKER MagicBox|
|Product Size||370 x 370 x 446mm|
|Chamber Size||310 x 310 x 215mm|
|Compatible FDM Materials||ABS|
|Operating Enviroment||Well ventilated area|
Maximum room temperature 85°F(29.4°C)
Humidity < 65% non condensing
Maximum altitude of up 10761 feet(3280meters)
|Power Requirements||100 - 240V|
1. 300mm (12 inches) distance to keep away
2. Spray acetone without heating.